ITTECH NEPAL

How To Install A Magnetic Door Lock Access Control System || IT TECH NEPAL Wiring Port 1.       +12 V working power Supply, input rang DC9-13.8V 2.      GND: Ground  3.      NO:- Normally open relays, current carrying capacity DC10A/30V] 4.      COM:- Common pin of relays, current carrying capacity DC10A/30V 5.      NC:- Normally close relay, current carrying capacity DC10A/30V 6.      OPEN:-Button switch, low level May cause open. 7.      DOOR:- Door status detector, connected to the door detector, low level means door closed 8.      ALM:- Alarm output port, be low level when emergency occurs, currency is 100mA. 9.      WG0;- Wigand 26 reader data lines(data 0) 10. WG1:-Wigand 26 reader data lines(data 1)  11. BELL:- the doorbell switch Indicator: 1.      POWER: - Power indicator. 2.      MODE:-Mode light constantly means that has entered the management state MODE flashes means normal state. 3.      OK: - Ok Flashing means unlocked. Reset But

opening balance of  Bank         100000/- lone taken  500000/- Share capital   200000/- Share Investment  50000/- Land and building 1000000/- Sundry Debtors   100000/- Sundry Creditor   20000/- Advance Received 5000/- 1.Loan repayment Rs 200000/- with interest Rs. 5000/- 2.Cash received Rs. 80000/- of sundry debtors Rs. 20000/- is doubt full not w/off. 3. Investment of Share refund with interest Rs. 8000/- . 4. 50000/- with adjusting prepaid. 5. Mr Shrawan Neupane entered  on business   with capital Rs. 200000/-. 6. The amount of advanced received transfer to income. Required  '       Prepare Profit and loss Account          Prepare Balance Sheet .

Launch your Visual Basic .NET or Visual Studio software. When the software first loads, you'll see a screen something like this one: There's a lot happening on the start page. But basically, this is where you can start a new project, or open an existing one. The first Tab, Projects, is selected. At the moment, the area labelled "Open an Existing Project" is blank. This is what you'll see when you run the software for the first time (because you haven't created a project yet). When you create a project, the Name you gave it will be displayed on this page, as a hyperlink. Clicking the link will open the project. At the bottom of the screen, there are two buttons: "New Project" and "Open Project". To get started, click the "New Project" button. When you do, you'll see this dialogue box appear: As a beginner, you'll normally want the option selected: "Windows Application", in the "Visual Basic Projects"